[Voyage-linux] Can't boot with voyage 0.3
Nuno Ferreira
(spam-protected)
Sun May 14 21:47:28 HKT 2006
Hi,
Soekris net4511 with prism 8470WD (atheros). Voyage 0.3 aborts boot
process with INIT: Id "T0" respawning too fast: disabled for 5 minutes.
syslog is attached.
Regards,
Nuno
-------------- next part --------------
Linux version 2.6.15-486-voyage (root at punknix-uml) (gcc version 3.3.5 (Debian 1:
3.3.5-13)) #1 PREEMPT Tue May 2 02:38:53 GMT 2006
BIOS-provided physical RAM map: LBA 980-8-32 125 Mbyte
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)e2 Int
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)---------
BIOS-e820: 0000000000100000 - 0000000004000000 (usable)000000
BIOS-e820: 00000000fff00000 - 0000000100000000 (reserved)00A0 10
64MB LOWMEM available.000 0107 0290 00 3F 00 0000E101 A0001000 11
DMI not present. 02000000 0107 0290 00 3F 00 0000E201 A0002000 05
ACPI: Unable to locate RSDP
Allocating PCI resources starting at 10000000 (gap: 04000000:fbf00000)
Built 1 zonelists
Kernel command line: auto BOOT_IMAGE=Linux ro root=301 console=ttyS0,1
oot=bios2222..66..11 LLooaaddiinngg LLiinnuuxx................................
No local APIC present or hardware disabled
Initializing CPU#0
PID hash table entries: 512 (order: 9, 8192 bytes)
Using pit for high-res timesource
Console: colour dummy device 80x25
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Memory: 61736k/65536k available (1639k kernel code, 3404k reserved, 653k data, 1
56k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Mount-cache hash table entries: 512
CPU: AMD 486 DX/4-WB stepping 04
Checking 'hlt' instruction... OK.
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.01 entry at 0xf7861, last bus=1
PCI: Using configuration type 1
ACPI: Subsystem revision 20051216
ACPI: Interpreter disabled.
PCI: Probing PCI hardware
PCI: Bus 1, cardbus bridge: 0000:00:09.0
IO window: 00001000-000010ff
IO window: 00001400-000014ff
PREFETCH window: 10000
MEM window: 12000000-13ffffff
squashfs: version 3.0prerelease (2006/1/24) Phillip Lougher
Initializing Cryptographic API
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered
pcc_acpi: loading...
i8042.c: Can't read CTR while initializing i8042.
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing enabled
?serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
hda: SanDisk SDCFB-128, CFA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: max request size: 128KiB
hda: 250880 sectors (128 MB) w/1KiB Cache, CHS=980/8/32
hda: cache flushes not supported
hda: hda1
mice: PS/2 mouse device common for all mice
padlock: VIA PadLock not detected.
NET: Registered protocol family
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 4096 (order: 2, 16384 bytes)
TCP bind hash table entries: 4096 (order: 2, 16384 bytes)
TCP: Hash tables configured (established 4096 bind 4096)
TCP reno registered
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
Using IPI Shortcut mode
hda: hda1
hda: hda1
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 156k freed
INIT: version 2.86 booting
Activating swap.
System time was Tue Jan 1 15:39:59 UTC 1980.
Setting the System Clock using the Hardware Clock as reference...
System Clock set. System local time is now Tue Jan 1 15:40:01 UTC 1980.
Cleaning up ifupdown...done.
Calculating module dependencies... done.
Loading modules...
natsemi
natsemi dp8381x driver, version 1.07+LK1.0.17, Sep 27, 2002
originally by Donald Becker <becker at scyld.com>
http://www.scyld.com/network/natsemi.html
2.4.x kernel port by Jeff Garzik, Tjeerd Mulder
natsemi eth0: NatSemi DP8381[56] at 0xa0001000 (0000:00:12.0), 00:00:24:c5:dd:28
, IRQ 11, port TP.
natsemi eth1: NatSemi DP8381[56] at 0xa0002000 (0000:00:13.0), 00:00:24:c5:dd:29
, IRQ 5, port TP.
hostap_pci
hostap_pci: 0.4.4-kernel (Jouni Malinen <jkmaline at cc.hut.fi>)
All modules loaded.
device-mapper: 4.4.0-ioctl (2005-01-12) initialised: dm-devel at redhat.com
Creating device-mapper devices...done.
Checking all file systems...
fsck 1.37 (21-Mar-2005)
Setting kernel variables ...
... done.
Mounting local file
tmpfs on /rw type tmpfs (rw,size=8M)
Cleaning.
Running 0dns-down to make sure resolv.conf is ok...done.
Setting up networking...done.
Starting hotplug subsystem:
pci
Yenta: CardBus bridge found at 0000:00:09.0 [0000:0000]
Yenta: Enabling burst memory read transactions
Yenta: Using CSCINT to route CSC interrupts to PCI
Yenta: Routing CardBus interrupts to PCI
Yenta TI: socket 0000:00:09.0, mfunc 0x00000002, devctl 0x60
Yenta: ISA IRQ mask 0x0000, PCI irq 10
Socket status: 30000020
yenta_socket: loaded succe
pccard: CardBus card inserted into slot 0
ath_hal: module license 'Proprietary' taints kernel.
ath_hal: 0.9.16.16 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413)
wlan: 0.8.4.2 (svn 1527)
ath_rate_sample: 1.2 (svn 1527)
ath_pci: 0.9.4.5 (svn 1527)
PCI: Enabling device 0000:01:00.0 (0000 -> 0002)
wifi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
wifi0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36
Mbps 48Mbps 54Mbps
wifi0: turboG rates: 6Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbp
wifi0: H/W encryption support: WEP AES AES_CCM TKIP
wifi0: mac 5.9 phy 4.3 radio 4.6
wifi0: Use hw queue 1 for WME_AC_BE traffic
wifi0: Use hw queue 0 for WME_AC_BK traffic
wifi0: Use hw queue 2 for WME_AC_VI traffic
wifi0: Use hw queue 3 for WME_AC_VO traffic
wifi0: Use hw queue 8 for CAB traffic
wifi0: Use hw queue 9 for beacons
wifi0: Atheros 5212: mem=0x12000000, irq=10
natsemi: already loaded
natsemi: already loaded
pci [success]
usb
usbcore: registered new driver usbfs
usbcore: registere
USB Universal Host Controller Interface driver v2.3
usb [failed]
isapnp
isapnp [success]
ide
ide [success]
input
input [success]
scsi
scsi [success]
done.
Setting up IP spoofing protection: rp_filter.
Enabling packet forwarding...done.
Configuring network interfaces...run-parts: /etc/network/if-pre-up.d/0_wpasuppli
cant exited with return code 1
run-parts: /etc/network/if-pre-up.d/0_wpasupplicant exited with return code 1
Internet Software Consortium DHCP Client 2.0pl5
Copyright 1995, 1996, 1997, 1998, 1999 The Internet Software Consortium.
All rights reserved.
Please contribute if you find this software useful.
For info, please visit http://www.isc.org/dhcp-contrib.html
wifi0: unknown hardware address type 801
eth0: DSPCFG accepted after 0 usec.
eth0: link up.
eth0: Setting full-duplex based on negotiated link capability.
wifi0: unknown hardware address type 801
Listening on LPF/eth0/00:00:24:c5:dd:28
Sending on LPF/eth0/00:00:24:c5:dd:28
Sending on Socket/fallback/fallba
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 7
DHCPOFFER from 192.168.99.254
DHCPREQUEST on eth0 to 255.255.255.255 port 67
DHCPACK from 192.168.99.254
bound to 192.168.99.14 -- renewal in 300 seconds.
done.
Cleaning /tmp /var/run /var/lock.
Setting the System Clock using the Hardware Clock as reference...
System Clock set. Local time: Tue Jan 1 15:41:11 GMT 1980
Initializing random number generator...done.
INIT: Entering runlevel: 2
Starting system log daemon: syslogd.
Starting kernel log daemon: k
Starting DNS forwarder and DHCP server: dnsmasqNET: Registered protocol family 1
0
lo: Disabled Privacy Extensions
IPv6 over IPv4 tunneling driver
.
Starting advanced IEEE 802.11 management: disabled via /etc/default/hostapd
Starting internet superserver: inetd.
nocatsplash daemon disabled - read /etc/default/nocatsplash.
Starting PCMCIA services: pcmcia: Detected deprecated PCMCIA ioctl usage.
pcmcia: This interface will soon be removed from the kernel; please expect break
age unless you upgrade to new tools.
pcmcia: see http://www.kernel.org/pub/linux/utils/kernel/pcmcia/pcmcia.html for
details.
cardmgr[1353]: wcs: IO port probe 0x100-0x4ff:atching 1 socket clean.
cs: IO port probe 0x800-0x8ff: clean.
cs: IO port probe 0xc00-0xcff: clean.
cs: IO port probe 0xa00-0xaff: clean.
done.
Starting PPTP Daemon: pptpd.
Starting OpenBSD Secure Shell server: sshd/var/run/sshd must be owned by root an
d not group or world-writable.
Starting periodic command scheduler: cron.
Starting watchdog daemon: watchdog.
sc520_wdt: WDT driver for SC520 initialised. timeout=30 sec (nowayout=0)
sc520_wdt: Watchdog timer is now enabled.
Remounting / as read-write ... Done.
Removing /etc/nologin ... Done.
Remounting / as read-only ... Done.
INIT: Id "T0" respawning too fast: disabled for 5 minutes
INIT: no more processes left in this runlevel
More information about the Voyage-linux
mailing list