[Voyage-linux] Voyage installation on 128MB CF card for WRAP.2E

[Veli-Matti Riepula]

> Veli-Matti Riepula wrote:
> > Hi,
> > I'm trying to install Voyage on WRAP.2E board but can't seem to get
> it to
> > boot properly. Maybe I've missed something obvious...
> >
> > I've installed 0.3pre3 on a 128MB CF card following the README
> instructions
> > (I've created one bootable primary linux partition with fdisk on the
> CF
> > card). The installation goes through without problems, apart from
> perl
> > warnings about locale settings.
> >
> > When I pop the card to the WRAP and boot it up, I can see the POST
> messages
> > and then a message saying
> >
> > "GRUB loading stage1.5.
> >
> > GRUB loading, please wait..."
> >
> > but that's it, it hangs there forever. Any hints how to kick this
> beyond
> > this point?

> Hi Veli-Matti,
> 
> May be the serial port setting you choose is not correct when running
> voyage.update?
> 
> Regards,
> Punky

I've selected the same line rate as is used by WRAP BIOS by default (38400)
and target console as "serial terminal" (if I remember the option name
correctly). I do see some install notes where line rate of 9600 is
mentioned, do you mean that I would need to use different serial line rate
than what the WRAP BIOS is using? I thought that as I can see the notes
about "GRUB loading" then the issue would not be in the line rate.

Thanks,
Veli-Matti