[Voyage-linux] Voyage installation on 128MB CF card for WRAP.2E

[Kim-man "Punky" TSE]

Hi Matt,

I install use grub over a year and didn't have see a single problem, 
what is the host distro you install voyage on?

Again, please subscribe to voyage mailing list so that you can get 
community support. 

http://list.voyage.hk/mailman/listinfo/voyage-linux

Regards,
Punky

Matthew Lewis wrote:
> Hello,
>
> I had the same problem but when I selected Lilo for the boot manager all
> worked fine. Grub would not seam to work on my wrap board.
>
> Matt
>   


>
> Hi,
> I'm trying to install Voyage on WRAP.2E board but can't seem to get it to
> boot properly. Maybe I've missed something obvious...
>
> I've installed 0.3pre3 on a 128MB CF card following the README
> instructions
> (I've created one bootable primary linux partition with fdisk on the CF
> card). The installation goes through without problems, apart from perl
> warnings about locale settings.
>
> When I pop the card to the WRAP and boot it up, I can see the POST
> messages
> and then a message saying
>
> "GRUB loading stage1.5.
>
> GRUB loading, please wait..."
>
> but that's it, it hangs there forever. Any hints how to kick this beyond
> this point?
>
> Best regards,
> Veli-Matti
>
> _______________________________________________
> Voyage-linux mailing list
> Voyage-linux at list.voyage.hk
> http://list.voyage.hk/mailman/listinfo/voyage-linux
>   


-- 
 

P U N K N ! X  . c o m
Technology + Lifestyle
(http://www.punknix.com)

V O Y A G E . H K - http://www.voyage.hk
Linux - voyage-0.3pre3 is released!
Store - New stock for Senao NMP8601 and NMP8602 (100mW)!
      - New low price for Senao NMP-8602 Plus (400mW)!