[Voyage-linux] Traffic not passing through ALIX.6B2

[doctor drew]

Hello all,

I've just gotten Voyage 0.6.0 installed (I know, it's beta, but I needed a newer kernel) and after getting the 2 eth ports to come up, I can't get the thing to pass traffic.  Here's my setup:

DSL using PPPoE coming in on eth0, eth1 connected to a trendnet switch.  Eth2 is configured to hand out ip addresses using dnsmasq.

/etc/network/interfaces:
auto lo                                                                         
iface lo inet loopback                                                          
                                                                                
auto dsl-provider                                                               
iface dsl-provider inet ppp                                                     
pre-up /sbin/ifconfig eth0 up                                                   
provider dsl-provider                                                           
                                                                                
auto eth0

auto eth1                                                                       
iface eth1 inet static                                                          
       address 192.168.1.1                                                      
       netmask 255.255.255.0

Important part of /etc/dnsmasq.conf:
dhcp-range=eth1,192.168.1.100,192.168.1.110,4h 

My current route table:
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface   
217.0.116.203   *               255.255.255.255 UH    0      0        0 ppp0    
192.168.1.0     *               255.255.255.0   U     0      0        0 eth1    
default         *               0.0.0.0         U     0      0        0 ppp0 


So with this, I can:

a) Ping anything on either interface with no problem from the Voyage console.
b) Resolve ip addresses from the switch on eth1 side, but not recieve traffic. (I'm about 75% sure that my pings are getting out, but the replies arent getting back)

I've been fighting w/ this for a while now (adding routes, editing routes, deleting routes, using all of google's resources), what am I doing wrong?  Did I miss a Voyage config step or something more obvious that I should have known and will kick myself for later?  Thanks for any help!


Drew  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://list.voyage.hk/pipermail/voyage-linux/attachments/20081223/8ca9d1b1/attachment.html>