[Voyage-linux] vogage-lenny dhcp & ntpdate?

[Kim-man 'Punky' TSE]

Hi Frank,

See /CHANGELOG.  It mentioned that dhclient is replaced by pump. 

See /etc/network/if-up.d/ntpdate.  It seems ntpdate would run when an 
interface is up.

Regards,
Punky

Frank Parker wrote:
> When voyage-lenny boots with the /etc/network/interfaces config
> below...  how does it obtain the DHCP lease for eth0?  I can't find
> dhclient on the disk anywhere.  Ultimately, I am trying to get ntpdate
> to run every time the eth0 lease is obtained or renewed.  I don't need
> a full ntpd install.
>
> ---[snip /etc/network/interfaces ]---
> auto lo
> iface lo inet loopback
> auto eth0
> iface eth0 inet dhcp
> ---[/snip]---
>
> The eth0 interface is getting a DHCP lease as it should, but how?
>
> Also, since this file exists shouldn't ntpdate be running after each DHCP event?
> /etc/dhcp3/dhclient-exit-hooks.d/ntpdate
>
> -parker
>
> _______________________________________________
> Voyage-linux mailing list
> Voyage-linux at list.voyage.hk
> http://list.voyage.hk/mailman/listinfo/voyage-linux
>   


-- 
Regards,
Punky

Voyage Solutions (http://solution.voyage.hk)
* Embedded Solutions and Systems
  - Mesh Networking, Captive Portal, IP Surveillance, VoIP/PBX
  - Network Engineering, Development Platform and Consultation