[Voyage-linux] Voyage-MPD install

[Kim-man 'Punky' TSE]

Hi Jeff,

You need to go through step-by-step, from 1 - 6.  After 6, you will be prompted to go for writing to disk.

Regards,
Punky


On 12/21/2010 5:12 AM, malibujeff at yahoo.com wrote:
> Punky,
>
> Thanks for your help.
>
> I started over so I could answer your question.Once I got to this section,
>
>
> 4. Start voyage.update installation script
>
> 	# /usr/local/sbin/voyage.update
>
> Following the instruction to select /tmp/root as distribution directory, and
> /tmp/cf as mount point.  After the installation complete, simple reboot the
> board and Voyage will be started!
>
> I realized I was not sure about most of the questions.
> So, the first question was "what would you like to do?"  I answered 1-create new
> voyage Linux disk
>
> Second Question "What would you like to do?"
> 1-specify distribution directory
> 2-select target profile
> 3-select target disk
> 4-select target bootstrap loader
> 5-configure target console
> 6-partition and create file system
>
> Which do I pick?
>
>
>
> ----- Original Message ----
> From: Kim-man 'Punky' TSE<punkytse at punknix.com>
> To: malibujeff at yahoo.com
> Sent: Sun, December 19, 2010 9:06:33 PM
> Subject: Re: [Voyage-linux] Voyage-MPD install
>
> Hi Jeff,
>
> The screen should show all the partitions of your disks, what are they?
>
> On 12/20/2010 6:50 AM, malibujeff at yahoo.com wrote:
>>               Which device accesses the target disk {/dev/hde]?
>
> -- Regards,
> Punky
>
> Voyage Solutions (http://solution.voyage.hk)
> * Embedded Solutions and Systems
>    - Mesh Networking, Captive Portal, IP Surveillance, VoIP/PBX
>    - Network Engineering, Development Platform and Consultation
>
>
>


-- 
Regards,
Punky

Voyage Solutions (http://solution.voyage.hk)
* Embedded Solutions and Systems
   - Mesh Networking, Captive Portal, IP Surveillance, VoIP/PBX
   - Network Engineering, Development Platform and Consultation