[Voyage-linux] Basic Wifi problem

Big Booger (spam-protected)
Sat May 7 08:38:56 HKT 2011


Hi Punky

I have attached the output from running the commands you recommended.
#ifconfig -a
#route -n.

I didn't know what you meant by the serial console so I googled it.  Tommorow I 
will try to get a cable and enable it and let you know.

Thanx again,

Matt

root at voyage:~# ifconfig -a
ath0      Link encap:Ethernet  HWaddr 06:02:6f:44:e1:3e  
          inet addr:192.168.1.2  Bcast:192.168.1.255  Mask:255.255.255.0
          inet6 addr: fe80::402:6fff:fe44:e13e/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:1522 errors:0 dropped:0 overruns:0 frame:0
          TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:93400 (91.2 KiB)  TX bytes:1117 (1.0 KiB)

eth0      Link encap:Ethernet  HWaddr 00:0d:b9:1b:e3:e8  
          inet addr:192.168.1.31  Bcast:192.168.1.255  Mask:255.255.255.0
          inet6 addr: fe80::20d:b9ff:fe1b:e3e8/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:1978 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1234 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:142546 (139.2 KiB)  TX bytes:81661 (79.7 KiB)
          Interrupt:10 Base address:0xa000 

eth1      Link encap:Ethernet  HWaddr 00:0d:b9:1b:e3:e9  
          BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000 
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
          Interrupt:15 Base address:0xe000 

lo        Link encap:Local Loopback  
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:30 errors:0 dropped:0 overruns:0 frame:0
          TX packets:30 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0 
          RX bytes:2442 (2.3 KiB)  TX bytes:2442 (2.3 KiB)

wifi0     Link encap:UNSPEC  HWaddr 
00-02-6F-44-E1-3E-65-74-00-00-00-00-00-00-00-00  
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:1933 errors:0 dropped:0 overruns:0 frame:12
          TX packets:126 errors:5 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:280 
          RX bytes:317333 (309.8 KiB)  TX bytes:9096 (8.8 KiB)
          Interrupt:11 


root at voyage:~# route -n
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
192.168.1.0     0.0.0.0         255.255.255.0   U     0      0        0 eth0
192.168.1.0     0.0.0.0         255.255.255.0   U     0      0        0 ath0
0.0.0.0         192.168.1.1     0.0.0.0         UG    0      0        0 ath0
0.0.0.0         192.168.1.1     0.0.0.0         UG    0      0        0 eth0



----- Original Message ----
From: Kim-man 'Punky' TSE <punkytse at punknix.com>
To: Big Booger <furrybailey at yahoo.ca>
Cc: voyage-linux at voyage.hk
Sent: Fri, May 6, 2011 12:35:03 AM
Subject: Re: [Voyage-linux] Basic Wifi problem

Hi Matt,

This is the exactly the same config I have in my office eveyday, it works for me 
without problem.  Can you show the 

output of:

# ifconfig -a
# route -n

To further troubshoot you should have enable serial console in ALIX box in order 
to see what happens.

Regards,
Punky

On 5/6/2011 12:53 PM, Big Booger wrote:
> Hi
>
> I am having some wifi problems with an Alix board and an athereos wifi mini 
PCI
> card.  I have voyage mpd 7.7.0 on the alix.  I have the board running no 
>problem
> through ethernet, and the wifi card scans (see iwlist below).  Also when I run
> nmap on my network I get the ethernet connection showing and another address
> that I assume is the wifi connection.  I can ssh into the wifi address (at 
>least
> I assume it is the wifi address), but when I disconnect the ethernet cable my
> connection through the wifi address is disabled.  Does anyone have any insight
> into what is going on here?  I would like to have this alix board supply my 
DAC
> and connect to my Arch Server through wifi - i do not want to have to have an
> ethernet cable permenently connected to the board.  I have tried booting the
> board up with out an Ethernet cable connected, and nmap shows no new 
connection
> onto my network.  Any help is appreciated.
>
> I have attached some information below.  Let me know if I should supply any 
>more
> information.
>
> Regards,
> Matt
>
>
> > From running #iwlist ath0 scan
>   Cell 02 - Address: 06:26:F2:F4:31:E5
>                      ESSID:"TestMatt"
>                      Mode:Master
>                      Frequency:2.422 GHz (Channel 3)
>                      Quality=42/70  Signal level=-53 dBm  Noise level=-95 dBm
>                      Encryption key:on
>                      Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 6 Mb/s
>                                9 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s; 36 Mb/s
>                                48 Mb/s; 54 Mb/s
>                      Extra:bcn_int=200
>                      IE: IEEE 802.11i/WPA2 Version 1
>                          Group Cipher : TKIP
>                          Pairwise Ciphers (2) : CCMP TKIP
>                          Authentication Suites (1) : PSK
>                      IE: WPA Version 1
>                          Group Cipher : TKIP
>                          Pairwise Ciphers (2) : CCMP TKIP
>                          Authentication Suites (1) : PSK
>
> Extra:wme_ie=dd180050f2020101850003a4000027a4000042435e0062322f00
>
>
> Interfaces file contents:
> # Used by ifup(8) and ifdown(8). See the interfaces(5) manpage or
> # /usr/share/doc/ifupdown/examples for more information.
> auto lo
> iface lo inet loopback
>
> auto eth0
> iface eth0 inet dhcp
>
> auto ath0
> iface ath0  inet dhcp
>          madwifi-base wifi0
>          wireless-mode Managed
>          wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf
>
>
> Contents of wpa_supplicant.conf:
> network={
>          ssid="TestMatt"
>          #psk="password"
>          psk=96c98dc5ca179fe2286d29eb0dd5021ad44fac388c1aeae121b8de6e40e2fa65
>          key_mgmt=WPA-PSK
>          proto=WPA
> #       proto=RSN       #uncomment for WPA2
> }
>
>
> Output of # lspci
> 00:01.0 Host bridge: Advanced Micro Devices [AMD] CS5536 [Geode companion] 
Host
> Bridge (rev 33)
> 00:01.2 Entertainment encryption device: Advanced Micro Devices [AMD] Geode LX
> AES Security Block
> 00:09.0 Ethernet controller: VIA Technologies, Inc. VT6105M [Rhine-III] (rev 
>96)
> 00:0b.0 Ethernet controller: VIA Technologies, Inc. VT6105M [Rhine-III] (rev 
>96)
> 00:0e.0 Ethernet controller: Atheros Communications Inc. AR5413 802.11abg NIC
> (rev 01)
> 00:0f.0 ISA bridge: Advanced Micro Devices [AMD] CS5536 [Geode companion] ISA
> (rev 03)
> 00:0f.2 IDE interface: Advanced Micro Devices [AMD] CS5536 [Geode companion] 
>IDE
> (rev 01)
> 00:0f.4 USB Controller: Advanced Micro Devices [AMD] CS5536 [Geode companion]
> OHC (rev 02)
> 00:0f.5 USB Controller: Advanced Micro Devices [AMD] CS5536 [Geode companion]
> EHC (rev 02)
>
> _______________________________________________
> Voyage-linux mailing list
> Voyage-linux at list.voyage.hk
> http://list.voyage.hk/mailman/listinfo/voyage-linux


-- 
Regards,
Kim-man "Punky" Tse

* Open Source Embedded Solutions and Systems
   - Voyage Linux (http://linux.voyage.hk)
   - Voyage ONE   (http://linux.voyage.hk/voyage-one)
   - Voyage MPD   (http://linux.voyage.hk/voyage-mpd)
* Voyage Store   (http://store.voyage.hk)




More information about the Voyage-linux mailing list