[Voyage-linux] Voyage ONE vs other Elastix and Issues

[Matt Signorello]

If you are not doing trans-coding you should have more than enough resources.

For comparison - I sell a 500mhz Geode based system (512mb ram) which
can handle well into 15+ concurrent ulaw calls no problem. As well as
provide voicemail, conf bridge, etc. You can not load up on bridges as
the timing tends to get a little funny, however I have deployed well
over 50 of these types of systems with no issue.

The issue at hand in my opinion is that the AsteriskNOW gui is just
broken in some cases and under developed..

2012/2/11 Charlie Blaclock <charlieblalock at gmail.com>:
> Hardware:  Via Nano 1.3 GHz, 2 GB RAM, 2 GB Flash Memory Storage, enabled
> ulaw/alaw, voip.ms is the ITSP
>
>
> I was not doing anything except making test calls directly to Voice Mail
> box, Conference Bridge from my both Xlite 4 and 3CX Voip clients.  As I've
> said, I can make internal calls between using the VoIP client between each
> other from different PC, and I can make outbound calls via my ITSP
> (voip.ms); also indicates as connected to SIP provider on main page of
> portal.  I use this ITSP for various clients of mine using the other
> Asterisk distros just fine.
>
>
>
> On Sat, Feb 11, 2012 at 12:05 AM, Rich E Neese <r.neese at gmail.com> wrote:
>>
>> What is the specs on your hardware ? ram/cpu/mb/hd 5400/7200 rpm laptop
>> or desktop hd
>> What codec where you using ?
>> what soft/hard phone where you using
>> who was the end provider you where connected to ?
>> where you doing any transcoding?
>>
>> need to know alot more information to get a handle on the issue at hand
>
>
>
> _______________________________________________
> Voyage-linux mailing list
> Voyage-linux at list.voyage.hk
> http://list.voyage.hk/mailman/listinfo/voyage-linux
>