[Voyage-linux] Alix3D3 + Voyage 0.8.0 (daily build 20120308): no LEDs, no watchdog

[Kim-man 'Punky' TSE]

Hi Achim,

See below, use alix.force=1 for 3.2.x kernel.

config ALIX
         bool "PCEngines ALIX System Support (LED setup)"
         select GPIOLIB
         ---help---
           This option enables system support for the PCEngines ALIX.
           At present this just sets up LEDs for GPIO control on
           ALIX2/3/6 boards.  However, other system specific setup should
           get added here.

           Note: You must still enable the drivers for GPIO and LED support
           (GPIO_CS5535 & LEDS_GPIO) to actually use the LEDs

           Note: You have to set alix.force=1 for boards with Award BIOS.

On 3/9/2012 5:10 PM, Achim Vollhardt wrote:
> Hello Jim and Punky,
>
> just tried the most recent daily build on the ALIX 3D3, but even with the kernel boot parameter
>
> leds-alix2.force=1
>
> (which I had to add myself, despite choosing ALIX as installation profile)
>
> no LEDs and no /dev/watchdog.
>
> I suspect, these problems are connected with each other.
>
>
> The recent 'official' 0.8.0 release (20111030) was all fine.
>
>
> Regards,
> Achim
>
> _______________________________________________
> Voyage-linux mailing list
> Voyage-linux at list.voyage.hk
> http://list.voyage.hk/mailman/listinfo/voyage-linux


-- 
Regards,
Kim-man "Punky" Tse

* Open Source Embedded Solutions and Systems
   - Voyage Linux (http://linux.voyage.hk)
   - Voyage ONE   (http://linux.voyage.hk/voyage-one)
   - Voyage MPD   (http://linux.voyage.hk/voyage-mpd)
* Voyage Store   (http://store.voyage.hk)