[Voyage-linux] PXE boot problem with 0.9-rc2: no IP address configured when no ethdevice kernel parameter

[Kim-man 'Punky' TSE]

Hi Teco,

On 1/10/2013 2:54 AM, Teco Boot wrote:
> Hi,
>
> I tested the 0.9-rc2 with PXE. I face a problem when using same kernel parameters as I used before, I did not use the ethdevice=eth0.
>
>
Adding "ethdevice=..." is the way it is known to work.  You can put a comma-separated list, e.g. ethdevice=eth0,eth1, if 
you have multiple interfaces.

-- 
Regards,
Kim-man "Punky" Tse

* Open Source Embedded Solutions and Systems
   - Voyage Linux (http://linux.voyage.hk)
   - Voyage ONE   (http://linux.voyage.hk/voyage-one)
   - Voyage MPD   (http://linux.voyage.hk/voyage-mpd)
* Voyage Store   (http://store.voyage.hk)