[Voyage-linux] Voyage setting frequency on CM9
Matthias Lemke
(spam-protected)
Tue Aug 16 23:11:05 HKT 2005
> Hi Folks,
>
> I'm running 2.6.8-486-voyage on Wrap2.C with Wistron CM9 Atheros
> 802.11a/b/g miniPCI wireless card.
>
> This is supposed to be a tri-band card (http://www.pcengines.ch/cm9.htm)
> but mine seems to be stuck in 802.11a mode (5.2Ghz). How do I reset this
> for 802.11b (2.4Ghz)?
first you should load the module with right countrycode.
next you can do a
iwpriv ath0 mode 2
its more b only.
found this info on http://www.fehu.org/atheros-en.html
regards
>
>> ath0 IEEE 802.11a ESSID:"orbit8.net"
>> Mode:Master Frequency:5.2 GHz Access Point:
>> 00:0B:6B:35:FB:B6
>> Bit Rate:0 kb/s Tx-Power:50 dBm Sensitivity=0/3
>> Retry:off RTS thr:off Fragment thr:off
>> Encryption key:off
>> Power Management:off
>> Link Quality=0/94 Signal level=-95 dBm Noise level=-95 dBm
>> Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
>> Tx excessive retries:0 Invalid misc:0 Missed beacon:0
>
> my /etc/network/interfaces:
>
>> ## miniPCI wireless interface ##
>> auto ath0
>> iface ath0 inet static
>> address 192.168.190.254
>> netmask 255.255.255.0
>> broadcast 192.168.190.255
>> up iwconfig ath0 mode master
>> up iwconfig ath0 essid my_net
>> up iwconfig ath0 channel 6
>> up iwconfig ath0 rate 2M
>> up iwconfig ath0 key off
>
> I've read the man pages for iwconfig and iwpriv and tried -
>
>> Wrap26:~# iwconfig eth0 freq 2.422G
>> Error for wireless request "Set Frequency" (8B04) :
>> SET failed on device eth0 ; Operation not supported.
>> Wrap26:~# iwconfig eth0 channel 3
>> Error for wireless request "Set Frequency" (8B04) :
>> SET failed on device eth0 ; Operation not supported.
>
> Nothing seems to work. Can anyone help?
>
> Thanks
>
> Colin
>
>
>
> _______________________________________________
> Voyage-linux mailing list
> Voyage-linux at list.voyage.hk
> http://list.voyage.hk/mailman/listinfo/voyage-linux
>
More information about the Voyage-linux
mailing list