[Voyage-linux] R6040 Support in Voyage 6.1

Kim-man 'Punky' TSE (spam-protected)
Wed Jun 24 15:04:29 HKT 2009


Hi Max,

My analysis is still not conclusive.
Before you switch to 0.5.2, try "ifup eth0" to see if you can bring up 
eth0 and function properly. 

Regards,
Punky



Max Bridgewater wrote:
> Hi Punky,
>
> After seing the result of ifconfig, i also had some suspicion about 
> DHCP. But then,  earlier today (about 4h ago) I booted the very same 
> box with Voyage 0.5.2, in the very same position, with the very same 
> ethernet cable, connected to the very same router. And i tried booting 
> the 0.6.1 version at least twice. I thus, doubt that it is a DHCP 
> problem. But if you want me to, i can try to boot again with 0.5.2.
>
> Maybe it would be easier to start from Voyage 0.5.2? I couldn't figure 
> out how to customize it though.
>
> Cheers,
> Max.
>
> On Wed, Jun 24, 2009 at 2:38 AM, Kim-man 'Punky' TSE 
> <punkytse at punknix.com <mailto:punkytse at punknix.com>> wrote:
>
>     Hi Max,
>
>     >From ifconfig, eth0 should be the network interface.  It is just
>     that eth0 is not started or failed in getting DHCP lease?
>
>     Something a bit strange is that eth0 should use IRQ15 but I can't
>     find it in /proc/interrupts.
>
>
>     Regards,
>     Punky
>
>     Max Bridgewater wrote:
>
>         Hi Punky,
>
>         Attached are three documents with the result of each of these
>         commands.
>
>         Ad Sean: curious to know which version of Voyage are you
>         running? I've never tried the CF because my notebook doesn't
>         support one.
>
>         Thanks again,
>         Max.
>
>         On Wed, Jun 24, 2009 at 2:10 AM, Kim-man 'Punky' TSE
>         <punkytse at punknix.com <mailto:punkytse at punknix.com>
>         <mailto:punkytse at punknix.com <mailto:punkytse at punknix.com>>>
>         wrote:
>
>            Hi Max,
>
>            I see r6040 driver is loaded via udev.  Please show me the
>         output
>            of the following:
>            1. lspci -v
>            2. ifconfig -a
>            3. cat /proc/interrupts
>
>            - Punky
>
>
>
>     -- 
>     Regards,
>     Punky
>
>     Voyage Solutions (http://solution.voyage.hk)
>     * Embedded Solutions and Systems
>      - Mesh Networking, Captive Portal, IP Surveillance, VoIP/PBX
>      - Network Engineering, Development Platform and Consultation
>              
>
>


-- 
Regards,
Punky

Voyage Solutions (http://solution.voyage.hk)
* Embedded Solutions and Systems
  - Mesh Networking, Captive Portal, IP Surveillance, VoIP/PBX
  - Network Engineering, Development Platform and Consultation
  
	





More information about the Voyage-linux mailing list