[Voyage-linux] R6040 Support in Voyage 6.1

[Max Bridgewater]

Hi Punky,

After seing the result of ifconfig, i also had some suspicion about DHCP.
But then,  earlier today (about 4h ago) I booted the very same box with
Voyage 0.5.2, in the very same position, with the very same ethernet cable,
connected to the very same router. And i tried booting the 0.6.1 version at
least twice. I thus, doubt that it is a DHCP problem. But if you want me to,
i can try to boot again with 0.5.2.

Maybe it would be easier to start from Voyage 0.5.2? I couldn't figure out
how to customize it though.

Cheers,
Max.

On Wed, Jun 24, 2009 at 2:38 AM, Kim-man 'Punky' TSE
<punkytse at punknix.com>wrote:

> Hi Max,
>
> From ifconfig, eth0 should be the network interface.  It is just that eth0
> is not started or failed in getting DHCP lease?
>
> Something a bit strange is that eth0 should use IRQ15 but I can't find it
> in /proc/interrupts.
>
> Regards,
> Punky
>
> Max Bridgewater wrote:
>
>> Hi Punky,
>>
>> Attached are three documents with the result of each of these commands.
>>
>> Ad Sean: curious to know which version of Voyage are you running? I've
>> never tried the CF because my notebook doesn't support one.
>>
>> Thanks again,
>> Max.
>>
>> On Wed, Jun 24, 2009 at 2:10 AM, Kim-man 'Punky' TSE <
>> punkytse at punknix.com <mailto:punkytse at punknix.com>> wrote:
>>
>>    Hi Max,
>>
>>    I see r6040 driver is loaded via udev.  Please show me the output
>>    of the following:
>>    1. lspci -v
>>    2. ifconfig -a
>>    3. cat /proc/interrupts
>>
>>    - Punky
>>
>>
>
> --
> Regards,
> Punky
>
> Voyage Solutions (http://solution.voyage.hk)
> * Embedded Solutions and Systems
>  - Mesh Networking, Captive Portal, IP Surveillance, VoIP/PBX
>  - Network Engineering, Development Platform and Consultation
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://list.voyage.hk/pipermail/voyage-linux/attachments/20090624/09c348da/attachment.html>