[Voyage-linux] Re: Bridging Wired and Wireless

[DH2SE]

Hi all,

I do have the same problem as Frank P. but with the difference, that I'm
using the wlan0 device as a client (managed mode) to my AP. I would like to
supply other PC's through the eth0 and eth1 port. I tried the bridge-utils
with a config as mentioned in this thread before but without any success.

Here is my /etc/network/interfaces

auto lo
iface lo inet loopback

auto wlan0
iface wlan0 inet static
 address 192.168.0.30
 netmask 255.255.255.0
 wireless-essid test-net
 gateway 192.168.0.1
 network 192.168.0.0
 dns-nameservers 192.168.0.1
 pre-up wpa_supplicant -B -Dwext -iwlan0 -c/etc/wpa_supplicant.conf
 up iwconfig wlan0 txpower 16dBm
 post-down killall -q wpa_supplicant

auto eth0
iface eth0 inet manual
 post-up /sbin/iptables-restore < /etc/network/firewall
 post-down /sbin/iptables -t nat -F

Does anyone may help me please? Please explain step-by-step. I'm a Linux
Newbie, thank you!

Regards,

Howard

-- 
View this message in context: http://voyage-linux.34677.n3.nabble.com/Bridging-Wired-and-Wireless-tp416318p2081762.html
Sent from the Voyage Linux mailing list archive at Nabble.com.