[Voyage-linux] Alix3D3 + Voyage 0.8.0 (daily build 20120308): no LEDs, no watchdog

[Achim Vollhardt]

Hi Punky,

root at freq:~# dmesg |grep alix
[    1.457561] alix: forced to skip BIOS test, assume system is 
ALIX.2/ALIX.3
root at freq:~#


Thanks,
Achim

On 11.03.2012 03:28, Punky Tse wrote:
> Hi Achim,
>
> What is the output of "dmesg |grep alix"?
>
> The below CONFIG_*=y means those modules are compiled into the kernel
> instead of a module. This is required for 3.2.x so far I tested.
> Otherwise even on ALIX3D2 no led devices could be created.
>
> On 3/9/2012 6:47 PM, Achim Vollhardt wrote:
>> root at freq:~# cat /boot/config-3.2.6-voyage |egrep "LEDS_G|GPIO_CS|ALIX"
>> CONFIG_ALIX=y
>> CONFIG_GPIO_CS5535=y
>> CONFIG_LEDS_GPIO=y
>>
>> root at freq:~# cat /proc/cmdline
>> root=LABEL=ROOT_FS console=ttyS0,38400n8 alix.force=1
>>
>> root at freq:~# dmesg |grep led
>> [ 0.146389] pci 0000:00:09.0: PME# disabled
>> [ 0.154573] pci 0000:00:0f.4: PME# disabled
>> [ 0.156998] pci 0000:00:0f.5: PME# disabled
>> [ 0.181378] ACPI: PCI Interrupt Link [LNKC] (IRQs 5 10 11) *0, disabled.
>> [ 1.810944] Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled
>> [ 2.014465] cs5535-mfd 0000:00:0f.0: MFD add devices failed: -16
>> [ 2.032596] cs5535-mfd: probe of 0000:00:0f.0 failed with error -16
>> [ 3.027859] i8042: probe of i8042 failed with error -5
>> [ 3.086104] leds-gpio: probe of leds-gpio failed with error -22
>> [ 4.209203] amd74xx 0000:00:0f.2: IDE port disabled
>> [ 5.450254] ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11
>> [ 5.603227] ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 10
>> [ 7.647555] ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 10
>> [ 8.289642] geode-aes: GEODE AES engine enabled.
>>
>
>