[Voyage-linux] Alix3D3 + Voyage 0.8.0 (daily build 20120308): no LEDs, no watchdog

[Punky Tse]

Hi Achim,

What is the output of "dmesg |grep alix"?

The below CONFIG_*=y means those modules are compiled into the kernel 
instead of a module.  This is required for 3.2.x so far I tested.  
Otherwise even on ALIX3D2 no led devices could be created.

On 3/9/2012 6:47 PM, Achim Vollhardt wrote:
> root at freq:~# cat /boot/config-3.2.6-voyage |egrep "LEDS_G|GPIO_CS|ALIX"
> CONFIG_ALIX=y
> CONFIG_GPIO_CS5535=y
> CONFIG_LEDS_GPIO=y
>
> root at freq:~# cat /proc/cmdline
> root=LABEL=ROOT_FS  console=ttyS0,38400n8 alix.force=1
>
> root at freq:~# dmesg |grep led
> [    0.146389] pci 0000:00:09.0: PME# disabled
> [    0.154573] pci 0000:00:0f.4: PME# disabled
> [    0.156998] pci 0000:00:0f.5: PME# disabled
> [    0.181378] ACPI: PCI Interrupt Link [LNKC] (IRQs 5 10 11) *0, 
> disabled.
> [    1.810944] Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled
> [    2.014465] cs5535-mfd 0000:00:0f.0: MFD add devices failed: -16
> [    2.032596] cs5535-mfd: probe of 0000:00:0f.0 failed with error -16
> [    3.027859] i8042: probe of i8042 failed with error -5
> [    3.086104] leds-gpio: probe of leds-gpio failed with error -22
> [    4.209203] amd74xx 0000:00:0f.2: IDE port disabled
> [    5.450254] ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11
> [    5.603227] ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 10
> [    7.647555] ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 10
> [    8.289642] geode-aes: GEODE AES engine enabled.
>


-- 

Regards,
Kim-man "Punky" Tse

* Open Source Embedded Solutions and Systems
   - Voyage Linux (http://linux.voyage.hk)
   - Voyage ONE   (http://linux.voyage.hk/voyage-one)
   - Voyage MPD   (http://linux.voyage.hk/voyage-mpd)
* Voyage Store   (http://store.voyage.hk)