[Voyage-linux] Alix3D3 + Voyage 0.8.0 (daily build 20120308): no LEDs, no watchdog

[Achim Vollhardt]

Good Morning Punky,

root at freq:~# dmesg |grep cs5535
[    2.014465] cs5535-mfd 0000:00:0f.0: MFD add devices failed: -16
[    2.032596] cs5535-mfd: probe of 0000:00:0f.0 failed with error -16
[    8.459929] snd_cs5535audio 0000:00:0f.3: PCI INT B -> Link[LNKB] -> 
GSI 11 (level, low) -> IRQ 11
[    8.733174] snd_cs5535audio 0000:00:0f.3: setting latency timer to 64
root at freq:~#

I have another Voyage 0.7.5 +Alix 3D3 running and the result is the 
same, although its LEDs work.

Thanks,
Achim



On 12.03.2012 04:12, Kim-man 'Punky' TSE wrote:
> Hi Achim,
>
> I believe what you have done is correct. The problem is that 3.2 kernel
> change the way the leds work on ALIX and seems it eventually break on
> ALIX3d3.
>
> At last, what does "dmesg|grep cs5535" shows?
>
> On 3/11/2012 4:33 PM, Achim Vollhardt wrote:
>> Hi Punky,
>>
>> root at freq:~# dmesg |grep alix
>> [ 1.457561] alix: forced to skip BIOS test, assume system is
>> ALIX.2/ALIX.3
>> root at freq:~#
>>
>>
>> Thanks,
>> Achim
>>
>> On 11.03.2012 03:28, Punky Tse wrote:
>>> Hi Achim,
>>>
>>> What is the output of "dmesg |grep alix"?
>>>
>>> The below CONFIG_*=y means those modules are compiled into the kernel
>>> instead of a module. This is required for 3.2.x so far I tested.
>>> Otherwise even on ALIX3D2 no led devices could be created.
>>>
>>> On 3/9/2012 6:47 PM, Achim Vollhardt wrote:
>>>> root at freq:~# cat /boot/config-3.2.6-voyage |egrep "LEDS_G|GPIO_CS|ALIX"
>>>> CONFIG_ALIX=y
>>>> CONFIG_GPIO_CS5535=y
>>>> CONFIG_LEDS_GPIO=y
>>>>
>>>> root at freq:~# cat /proc/cmdline
>>>> root=LABEL=ROOT_FS console=ttyS0,38400n8 alix.force=1
>>>>
>>>> root at freq:~# dmesg |grep led
>>>> [ 0.146389] pci 0000:00:09.0: PME# disabled
>>>> [ 0.154573] pci 0000:00:0f.4: PME# disabled
>>>> [ 0.156998] pci 0000:00:0f.5: PME# disabled
>>>> [ 0.181378] ACPI: PCI Interrupt Link [LNKC] (IRQs 5 10 11) *0,
>>>> disabled.
>>>> [ 1.810944] Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled
>>>> [ 2.014465] cs5535-mfd 0000:00:0f.0: MFD add devices failed: -16
>>>> [ 2.032596] cs5535-mfd: probe of 0000:00:0f.0 failed with error -16
>>>> [ 3.027859] i8042: probe of i8042 failed with error -5
>>>> [ 3.086104] leds-gpio: probe of leds-gpio failed with error -22
>>>> [ 4.209203] amd74xx 0000:00:0f.2: IDE port disabled
>>>> [ 5.450254] ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11
>>>> [ 5.603227] ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 10
>>>> [ 7.647555] ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 10
>>>> [ 8.289642] geode-aes: GEODE AES engine enabled.
>>>>
>>>
>>>
>
>