[Voyage-linux] Alix3D3 + Voyage 0.8.0 (daily build 20120308): no LEDs, no watchdog

[Achim Vollhardt]

root at freq:~# cat /boot/config-3.2.6-voyage |egrep "LEDS_G|GPIO_CS|ALIX"
CONFIG_ALIX=y
CONFIG_GPIO_CS5535=y
CONFIG_LEDS_GPIO=y

root at freq:~# cat /proc/cmdline
root=LABEL=ROOT_FS  console=ttyS0,38400n8 alix.force=1

root at freq:~# dmesg |grep led
[    0.146389] pci 0000:00:09.0: PME# disabled
[    0.154573] pci 0000:00:0f.4: PME# disabled
[    0.156998] pci 0000:00:0f.5: PME# disabled
[    0.181378] ACPI: PCI Interrupt Link [LNKC] (IRQs 5 10 11) *0, disabled.
[    1.810944] Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled
[    2.014465] cs5535-mfd 0000:00:0f.0: MFD add devices failed: -16
[    2.032596] cs5535-mfd: probe of 0000:00:0f.0 failed with error -16
[    3.027859] i8042: probe of i8042 failed with error -5
[    3.086104] leds-gpio: probe of leds-gpio failed with error -22
[    4.209203] amd74xx 0000:00:0f.2: IDE port disabled
[    5.450254] ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 11
[    5.603227] ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 10
[    7.647555] ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 10
[    8.289642] geode-aes: GEODE AES engine enabled.





On 09.03.2012 11:36, Kim-man 'Punky' TSE wrote:
> Hi Achim,
>
> What does the following commands shows?
>
> ~# cat /boot/config-3.2.6-voyage |egrep "LEDS_G|GPIO_CS|ALIX"
>
> ~# cat /proc/cmdline
>
> and check dmesg output something relate to alix or led:
>
>
> On 3/9/2012 6:25 PM, Achim Vollhardt wrote:
>> Hi Punky,
>> changed the switch in menu.lst to alix.force=1, but still no LEDs and
>> no /dev/watchdog.
>>
>>> Note: You must still enable the drivers for GPIO and LED support
>>> (GPIO_CS5535 & LEDS_GPIO) to actually use the LEDs
>>
>> How is this done? Sorry for the likely stupid question.. I am new to
>> Linux and tried google, but with little success..
>>
>> Thanks,
>> Achim
>>
>>
>>
>>
>
>